In this guide, we will show you how to enable and increase the swap file on your Raspberry Pi.
The swap file is used to increase the system’s total accessible memory beyond its hardware capabilities.
Source: Increasing Swap on a Raspberry Pi – Pi My Life Up
In this project, we will show you how to set up a WireGuard VPN on the Raspberry Pi.
WireGuard is a new VPN protocol that has recently been going a lot of popularity.
There are a couple of advantages to using the WireGuard VPN on your Raspberry Pi over OpenVPN.
Source: Setting up a WireGuard VPN on the Raspberry Pi – Pi My Life Up
With a little time and energy, anyone can build a little computer that kills advertisements and makes browsing more manageable.
Source: How to Set Up a Pi Hole to Block Ads and Speed Up Your Internet (Vice)
Archiving data can save you in a pinch—but what if you forget to make a backup? This Raspberry Pi project, created by Curtis Gross, solves that problem by automating the process in a convenient NAS device. The end result is a Pi-powered time machine server with all of your data stored in archives.
Source: Raspberry Pi Time Machine and NAS Backs Up Data For You | Tom’s Hardware
This tutorial for installing macOS Catalina using OpenCore has been adapted for Proxmox from Kholia’s OSX-KVM project and Leoyzen’s OpenCore configuration for KVM. You can get the full sourcecode on my GitHub here.
If you’d like to use Clover instead, use my older tutorial, but OpenCore works better!
Source: Installing macOS Catalina 10.15 on Proxmox 6.1 or 6.2 using OpenCore – Nicholas Sherlock
This is a step by step beginner guide shows how to share a folder over local network via SMB/CIFS protocol in Ubuntu 20.04 Gnome desktop.
Source: How to Share A Folder via SMB/CIFS Protocol in Ubuntu 20.04 | UbuntuHandbook
In this guide, you will learn how to set up Porcupine on your Raspberry Pi to enable wake word detection.
Source: Wake Word Detection on the Raspberry Pi with Porcupine – Pi My Life Up
A firmware update lets you use any USB device to boot a Pi 4.
Source: How to Boot Raspberry Pi 4 From a USB SSD or Flash Drive | Tom’s Hardware
In this article, I’ll be sharing and documenting what I’ve learned during a recent situation where I had to install, setup, and configure ClamAV to run on Ubuntu 18.04 systems using real-time or as ClamAV calls it “on-access scanning”.
Source: Installation & Configuration of ClamAV Antivirus on Ubuntu 18.04 (Aaron Brighton)
Recent Comments